openstack.network.v2.security_group_rule

The SecurityGroupRule Class

The SecurityGroupRule class inherits from Resource.

class openstack.network.v2.security_group_rule.SecurityGroupRule(_synchronized=False, connection=None, **attrs)

The base resource

Parameters

• _synchronized (bool) – This is not intended to be used directly. See new() and existing().

• connection (openstack.connection.Connection) – Reference to the Connection being used. Defaults to None to allow Resource objects to be used without an active Connection, such as in unit tests. Use of self._connection in Resource code should protect itself with a check for None.

created_at

Timestamp when the security group rule was created.

description

The security group rule description.

direction

ingress or egress: The direction in which the security group rule is applied. For a compute instance, an ingress security group rule is applied to incoming ingress traffic for that instance. An egress rule is applied to traffic leaving the instance.

ether_type

Must be IPv4 or IPv6, and addresses represented in CIDR must match the ingress or egress rules.

port_range_max

The maximum port number in the range that is matched by the security group rule. The port_range_min attribute constrains the port_range_max attribute. If the protocol is ICMP, this value must be an ICMP type.

port_range_min

The minimum port number in the range that is matched by the security group rule. If the protocol is TCP or UDP, this value must be less than or equal to the value of the port_range_max attribute. If the protocol is ICMP, this value must be an ICMP type.

project_id

The ID of the project this security group rule is associated with.

protocol

The protocol that is matched by the security group rule. Valid values are null, tcp, udp, and icmp.

remote_group_id

The remote security group ID to be associated with this security group rule. You can specify either remote_group_id or remote_address_group_id or remote_ip_prefix.

remote_address_group_id

The remote address group ID to be associated with this security group rule. You can specify either remote_group_id or remote_address_group_id or remote_ip_prefix.

remote_ip_prefix

The remote IP prefix to be associated with this security group rule. You can specify either remote_group_id or remote_address_group_id or remote_ip_prefix. This attribute matches the specified IP prefix as the source or destination IP address of the IP packet depending on direction.

security_group_id

The security group ID to associate with this security group rule.

tenant_id

The ID of the project this security group rule is associated with.

updated_at

Timestamp when the security group rule was last updated.