https://blueprints.launchpad.net/networking-odl/+spec/journal-recovery
Journal entries in the failed state need to be handled somehow. This spec will try to address the issue and propose a solution.
Currently there is no handling for Journal entries that reach the failed state. A journal entry can reach the failed state for several reasons, some of which are:
These entries will be left in the journal table forever which is a bit wasteful since they take up some space on the DB storage and also affect the performance of the journal table. Albeit each entry has a negligble effect on it’s own, the impact of a large number of such entries can become quite significant.
A “journal recovery” routine will run as part of the current journal maintenance process. This routine will scan the journal table for rows in the “failed” state and will try to sync the resource for that entry.
The procedure can be best described by the following flow chart:
asciiflow:
+-----------------+
| For each entry |
| in failed state |
+-------+---------+
|
+-------v--------+
| Query resource |
| on ODL (REST) |
+-----+-----+----+
| | +-----------+
Resource | | Determine |
exists +--Resource doesn't exist--> operation |
| | type |
+-----v-----+ +-----+-----+
| Determine | |
| operation | |
| type | |
+-----+-----+ |
| +------------+ |
+--Create------> Mark entry <--Delete--+
| | completed | |
| +----------^-+ Create/
| | Update
| | |
| +------------+ | +-----v-----+
+--Delete--> Mark entry | | | Determine |
| | pending | | | parent |
| +---------^--+ | | relation |
| | | +-----+-----+
+-----v------+ | | |
| Compare to +--Different--+ | |
| resource | | |
| in DB +--Same------------+ |
+------------+ |
|
+-------------------+ |
| Create entry for <-----Has no parent------+
| resource creation | |
+--------^----------+ Has a parent
| |
| +---------v-----+
+------Parent exists------+ Query parent |
| on ODL (REST) |
+---------+-----+
+------------------+ |
| Create entry for <---Parent doesn't exist--+
| parent creation |
+------------------+
For every error during the process the entry will remain in failed state but the error shouldn’t stop processing of further entries.
The implementation could be done in two phases where the parent handling is done in a second pahse. For the first phase if we detect an entry that is in failed for a create/update operation and the resource doesn’t exist on ODL we create a new “create resource” journal entry for the resource.
This propsal utilises the journal mechanism for it’s operation while the only part that deviates from the standard mode of operation is when it queries ODL directly. This direct query has to be done to get ODL’s representation of the resource.
The maintenance thread will have another task to handle. This can lead to longer processing time and even cause the thread to skip an iteration. This is not an issue since the maintenance thread runs in parallel and doesn’t directly impact the responsiveness of the system.
Since most operations here involve I/O then CPU probably won’t be impacted.
Network traffic would be impacted slightly since we will attempt to fetch the resource each time from ODL and we might attempt to fetch it’s parent. This is however negligble as we do this only for failed entries, which are expected to appear rarely.
The partial sync process could make this process obsolete (along with full sync), but it’s a far more complicated and problematic process. It’s better to start with this process which is more lightweight and doable and consider partial sync in the future.